Refurbished Equipment
Refurbished Contrast Injectors for Sale
Tested, refurbished Medrad Stellant CT and Spectris Solaris MR injection systems, delivered and installed. We will take your old unit in trade, and we service what we sell.
Every unit goes through our acceptance process before it is installed, 34 points on a Stellant and 22 on a Spectris Solaris: cleaned, inspected, resealed and lubricated, then flow-tested, pressure-tested and electrical safety-tested. You get the signed report the day we install it.
Platform detail sits on its own page: used Medrad Stellant CT injectors for CT, and used Medrad Spectris and Solaris injectors for MRI.
Looking for syringes? CT injector syringes and MRI injector syringes.
Available platforms
What We Sell
Availability changes constantly, so we do not publish a stock list. Tell us the platform and configuration you need and we will tell you what we can find and what it will cost delivered.
MEDRAD Stellant CT Injection System
CT
Single and two-syringe configurations.
- With or without the Certegra workstation
- Delivered and installed
- Syringe kits in the box
MEDRAD Spectris Solaris and Solaris EP
MRI
The Solaris MR platform.
- Including mobile configurations
- Delivered and installed
- Syringe kits in the box
What You Get at Installation
Not dropped on a loading dock. Every unit arrives ready to run patients the day we leave.
Ready the Day We Leave
If it faults, you call the people who put it in. See injector service and support.
Signed PM report
Every point on the checklist, with serial numbers and software version recorded. Handed to you the day we install.
Syringe kits
Enough to run patients on day one. We supply the reorders too.
Delivered and installed
Delivered, mounted, powered up and demonstrated in your room. Not left on a loading dock.
90-day parts warranty
Replacement parts and remote support. The clock starts at installation, not shipment.
Acceptance process, part 1
Inspected and Resealed
Every unit goes through our acceptance process, 34 points on a Stellant and 22 on a Spectris Solaris, before it is installed. The first half is hands-on: open it up, clean it, check it, reseal it.
What Gets Opened Up
Shown here for a Stellant CT. See the Spectris Solaris version.
Console and cabling
The display is decontaminated and checked for full-panel response. Every cable and the power cord is traced end to end for strain, abrasion and connector integrity.
Head covers and gaskets
Top and bottom covers, lens cap, pivot knuckle, front assembly and front cap seals are inspected at every joint. The head display and LED boards get the same check.
Pistons and syringe interface
Pistons, piston tips, flex cam rings and syringe sensors are cleaned and inspected. These are the parts that touch your syringes and move contrast.
Seals replaced and lubricated
Wear seals are replaced and freshly lubricated. Manual knobs, head cable and mount are checked for smooth travel and a secure fit.
Acceptance process, part 2
Tested Before It Leaves
The second half proves it works. Every result is recorded on the report you receive at installation.
What Gets Tested
Both sides, independently, every unit. Not a sample.
Operational check
Clock and date are set, then full operation is exercised from the console. Load controls are cycled and the syringe heater is verified to warm.
Syringe position
Seating and position detection are confirmed on each side independently. The system knows where the plunger is before it ever injects.
Flow and volume
Each side runs a timed test injection. Duration and delivered volume are measured against manufacturer tolerance.
Pressure and electrical safety
The pressure limit is verified on each side against its rated set point. Ground resistance and leakage current are measured before release.
Sound Familiar?
Already have one sitting unused? We buy used injectors, working or not.
"Ours is end of life and a new one will not get approved."
Bayer has set 12/31/2028 as end of life for the Stellant CT and Spectris Solaris EP. A refurbished unit often falls below the capital line where a new one does not.
"We need a second injector, not a flagship one."
A second CT room, a mobile unit or a backup does not need the newest platform. We match what you already run, so staff, protocols and disposables stay the same.
"We have an injector sitting in a storage room."
Trade it against a replacement, or we will buy it outright. Either way it stops taking up space.
"The last one showed up and nobody installed it."
Purchase, freight, install and first service call are usually four phone numbers. With us it is one, and we service what we sell.
Trade-In
Send us the make, model and serial of what you have now, along with a photo of the injector head and the console. We will tell you what it is worth against a replacement, or what we will pay for it outright if you are not replacing it. Working, non-working and end-of-life systems all have value to us, because we service these platforms and we use the parts. What a used injector is worth goes through it in detail.
Frequently Asked Questions
That depends on your finance department's threshold, but a refurbished unit often falls below the capital line where a new system does not. It is worth asking before you assume you need a capital request.
Every unit passes our acceptance process, 34 points on a Stellant and 22 on a Spectris Solaris, before it is installed: cleaning and inspection of the console and injector head, replacement and lubrication of wear seals, verification of the drive and syringe interfaces, timed flow and volume tests, a pressure limit check on each side, and electrical safety testing. You receive the signed report at installation.
Yes. The signed PM report is handed to you the day we install, and it records the measured result for each test, not just a pass or fail.
The software version is recorded on the report. If your department needs a specific version, tell us when you ask for a quote.
A 90-day parts warranty, covering replacement parts and remote support, running from the date of installation. Ask us about extended coverage if you want longer.
Yes. Delivery and installation are included, and we service what we sell.
If we match the platform you already run, yes. That is usually the point of buying a refurbished unit rather than a new generation, since your disposables, protocols and training all stay the same.
Yes, working or not. See used imaging equipment.
You can, and plenty of departments do, because the hardware is sound and the price is right. What matters is having someone to service it and supply the consumables afterwards, which is what we do. See Bayer injector end of life dates.
It depends on the platform and configuration. Tell us what you need and we will give you a real date rather than a range.
No obligation
Tell Us What You Need
Buying: the platform and configuration is enough to start. Trading or selling: make, model, serial and two photos, the injector head and the console.
Request a quote
We reply by the next business day.
Our Other Injector Services
Service Coverage
FDM Enterprises provides MRI, CT and contrast injector service, repair and calibration across the central and southeastern US.